|
|
|
Reasons |
|
|
||||||||||||||||||||||
|
Higher wind
velocities and cooler temperatures minimize scorch damage. Southern pine plantations averaging
10 to 12 feet in height can be burned by experienced people
under the right conditions without damage. Young plantations on industrial lands are
often burned for the first time when they are 15 to 20 feet tall using aerial ignition; close spacing
of ignition spots (e.g., 2 chains by 2
chains), and cool, damp conditions with some wind are a must to avoid crown
damage. Subsequent fuel reduction burns need not cover the entire area. The objective is to
break up fuel continuity. Fuel reduction on 75 to 80 percent
of the area is sufficient. An added advantage of "patchy" burns is that the
unburned islands provide cover for wildlife. These unburned patches will not have a dangerous
accumulation of fuels at the time of the next burn
if they resulted from a lack of fuel during the previous fire. If, however, they were too
wet to burn, these islands could result in a hot spot the next time if a heading fire was allowed to
sweep through them under appreciably
drier conditions. One reason excessive crown scorch should be avoided is because,
under some circumstances, it can add more fuel to the forest floor than the fire
consumed. Dispose of Logging Debris After harvest,
unmerchantable limbs and stems are left either scattered across the area or concentrated
at logging decks or delimbing gates, depending upon the method of logging. This material is an
impediment to both people and planting
equipment. If a wildfire occurs within the next few years, fireline construction can be
severely hindered; the result being larger burn acreages and higher regeneration losses. Although
not all large material will be consumed by a
prescribed fire, what is left will be exposed so it can be avoided by tractor-plow
operators. In stands that produce a large amount of cull material, the debris is often windrowed
and burned. This practice should, however, be
avoided whenever practical because of smoke management problems and the potential
for site degradation. Broadcast burning is generally a much better alternative. If the debris must
be piled before burning, construct round
"haystack" piles when the debris and underlying ground are both fairly dry.
This step will limit the amount of dirt in the pile. Piles containing large amounts of dirt can
seldom be burned efficiently. They almost always
smolder for long periods, creating unacceptable smoke problems. In some cases
overstory pines are left during harvest as seed trees, and in others an unevenaged management
system such as shelterwood is used. In both situations,
the logging debris can still be burned, but you must take more care to protect the
remaining trees. Prepare Sites for Seeding or Planting Prescribed burning is
useful when regenerating southern pine by direct seeding,
planting, or natural regeneration. On open sites, fire alone can expose adequate mineral
soil and control competing vegetation until seedlings become established. Where competing
vegetation cannot be adequately reduced by fire,
follow up with mechanical or chemical treatment. The fire will improve visibility so
that equipment operators can more easily see the stumps of the harvested trees, as well as any
other hazards. In addition, if the area is to be
bedded before planting, burning first consumes much of the debris. The result is more
tightly packed beds and thus better seedling survival. Where herbicides are used to kill
competition, subsequent burning will give additional
vegetation control. This step also permits more efficient and easier movement of
hand-planting crews. Prescribed fire also recycles nutrients, making them available for the next
timber crop. For natural regeneration, knowledge of
anticipated seed crop and date of earliest seed fall is essential. If the seed crop is
inadequate, burning can be postponed. Complete mineral soil exposure is not necessary or
desirable; a thin layer of litter should remain to
protect the soil. Generally, burning should be done several weeks prior to seed fall.
Timing varies with species and locality. |
|
|
||||||||||||||||||||||
|
red cockaded
woodpecker are also enhanced by burning. Wildlife benefits from burning are substantial. For
example, fruit and seed production is stimulated. Yield and
quality increases occur in herbage, legumes, and browse from hardwood sprouts.
Openings are created for feeding, travel, and dusting. Selecting the proper size, frequency,
and timing of burns is crucial to the successful use of
fire to improve wildlife habitat. Prescriptions should recognize the biological
requirements (such as nesting times) of the preferred wildlife species. Also consider the
vegetative condition of the stand and, most importantly, the
changes fire will produce in understory stature and species
composition. |
|
|
||||||||||||||||||||||||||||||||||||||||||
|
Generally, a
winter (dormant season) fire results in less root kill than a late spring or summer burn. One
system recommended in both the Piedmont and Coastal Plain is a
dormant season burn to reduce initial fuel mass, followed by two or more annual (if
enough fuel is present) or biennial summer burns. If not controlled, the hardwoods will form
a midstory and capture the site once the pine is
harvested. If a large pine component is wanted in the next rotation, these
unmerchantable hardwoods must be removed during site preparation - an expensive proposition.
Generally, fire is required in combination with other
treatments involving heavy equipment, chemicals, or both. In many locations the
preferred system is a combination summer burn and herbicide treatment. However, in the
lower Appalachians of South Carolina, another relatively
inexpensive technique is employed. All residual hardwoods are felled and the area
broadcast burned under exacting fuel and weather conditions. |
|
|
||||||||||||||||||||||
|
Prescribed
burning seems to reduce problems from Fomes annosus
root rot. This fungal disease is less frequent where periodic burns have reduced the
litter. The fire alters the microenvironment of the forest floor and perhaps destroys some fruiting
bodies and cauterizes tree stumps. Prescribed fire has been successfully used under very exacting fuel
and weather conditions to control cone insects such as the white pine cone beetle
(Conophthorns coniperda) while the pest is overwintering in
cones on the ground. Prescribed burning costs mush less than traditional chemical
control methods used to control this beetle. |
|
|
||||||||||||||||||||||||||||||||||||||||||||||||||
|
Enhance
Appearance Prescription burning improves recreation and aesthetic values. For example,
burning maintains open stands, produces vegetative changes, and increases numbers
and visibility of flowering annuals and biennials. Burning also maintains open spaces such as
mountain balds, and creates vistas. Unburned islands
increase vegetative diversity which attracts a wider variety of birds and animals. A
practical way to maintain many visually attractive vegetative communities and perpetuate many
endangered plant species is through the periodic use
of prescribed fire. Using fire to manage landscapes and enhance scenic values
requires judiciously planned and executed burns, especially where exposure to the public is great.
Burning techniques can be modified along roads and
in other heavily used areas to ensure low flame heights, which in turn will reduce
crown scorch and bark char while still opening up the stand and giving an unrestricted
view. |
|
|
||||||||||||||||||||||||||||||